![[Translate to Englisch (Nordamerika):] Servocret WSM Plus](/fileadmin/_processed_/8/3/csm_K_ServocretWSMPlus_f2453d0320.png)

Servocret WSM Plus
Wall preparation leveling compound
- For quick leveling and smoothing on walls and ceilings
- Ideal solution for fixing walls before installing large, thin gauged porcelain tiles
- For indoor use
- Extended coverage
- High productivity
- Easy processing
- Non-sag
- For leveling floor surfaces before installing tiles / natural stone
Cement based, non-sag, productive, light weight quick filler and leveling compound for smoothing and leveling wall and ceiling surfaces, filling and repairing larger areas. Interior (when used in wet areas a Kiesel Waterproofing Membrane must be applied first)). Due to the crystalline water binding, Servocret WSM Plus dries well and hardens even in thick layers with very little tension.
Suitable as a ready-to-install substrate for ceramics and natural stone, synthetic resin plasters and paints.
To produce a neutral, white surface, Servocret WSM Plus can be reworked with suitable fillers after priming.
The surface must be dry, clean and stable. Remove old and loose, water-soluble paints as well as loose plasters or wallpaper.
Prime absorbent substrates such as cement and lime cement plasters, concrete, mineral screeds and others with Okatmos® UG 30 or Okatmos® DSG. Non-absorbent substrates must be also primed Okatmos® UG 30 or Okatmos® DSG. Prime well prepared solid gypsum plasters in the dry area with Okatmos® DSG or Okatmos® UG 30.
Mix Servocret WSM Plus with clean and cool water using an electric mixer at max. Mix 600 rpm without any lumps. Mix only as much material as can be processed in 30-40 minutes. Mix again after approx. 5 minutes of slaking.
Then apply, model or remove the filler with a spatula or trowel. If necessary, rework the surface after it has started to harden (approx. 60 minutes) by felting or smoothing. Avoid direct sunlight and drafts during drying. In case of doubt, carry out a test
Color
Grey
Application
Interior
Thickness
2 - 30 mm (1/16” – 1 1/4”)
Application temperature
+ 5 °C - + 25 °C (41 °F - 77 °F)
Water demand
Approx. 1.4 U.S. gals. / 44 lbs powder, approx. 5.2 l / 20 kg powder
Slake time
Approx. 5 minutes (Re-stir)
Processing time*
Approx. 40 minutes
Ready for installation*
Ready for installation – of ceramic tiles*
Low in chrome
Approx. 6 months
*
At 68 °F (+20 °C) and 65 % relative humidity. Higher temperature and low humidity decreases, lower temperature and high humidity increase this value respectively.
Approx. 1.3 kg/m² per 1 mm thickness / 161 ft2 per 1/32”.
Coverage depends on the condition of the substrate.
Clean tools and tile surface immediately with water.
| Description | Item No. | |
|---|---|---|
| 54 x 20 kg / 44 lbs paper bags | 11031 |
The aforementioned information, especially the proposals for processing and utilizing our product, is based on our knowledge and experience. We recommend that you carry out your own tests in every case to ensure the suitability of our products for the intended process and processing purposes because of the different materials and the working conditions which lie beyond our area of influence. No liability can be derived from this advice or from verbal advice, unless we are responsible for (criminal) intent or gross negligence in this respect.