Servocret RS-N
Repair filler and patching compound
- For levelling and filling gradients in interior, exterior, wet areas, and pools
- High stability, for wall and floor surfaces
- For levelling unevenness up to 50 mm/ 2'' layer thickness
- For use under ceramic and natural stone flooring
- To improve concrete and cement stucco
Cement bonded, fixed, acrylic polymer modified repair and levelling patch for interior and exterior areas. Suitable for filling holes and breakouts on stairs, pedestals, on cement and calcium sulphate coatings, in the wall area on concrete and cement stucco, on ceilings, bases and supports of rough concrete and balcony plates under tiles and natural stone flooring. Can be used to adhere appropriate Styrofoam elements coated with cementitious product. Servocret RS-N securely adheres, is water-proof, resistant to weather and frost and has high compression strength after curing.
The substrates must be clean, free of contaminants oil and able to sustain a load. In the interior areas, prime absorbent substrates with Okatmos® DSG or Okatmos UG 30.
Prime non-absorbent substrates with Okatmos® DSG or Okatmos® UG 30. In exterior areas prime with Okatmos® DSG or Okatmos UG® 30 and let dry, apply contact layer as scratch filler and immediately afterward proceed with the filling work.
Mix Servocret RS-N with clean, cool water using an electric mixer at a max of 600 rpm until free of clumps. Apply, texture or remove with a spatula or trowel, rework the surface if necessary with a sponge board. After curing, in the interior areas, Servocret RS-N can be plastered over with Servofix or Servoplan compound or covered with ceramic or natural stone. Suitable for Worm pump application, e.g.: Putzmeister, Inotec. Protect fresh filler layers from direct sunlight, drafts and high temperatures by covering with PE film.
Follow additional installation and floor preparation guidelines located in the latest TTMAC and TCNA installation manuals.
Color
Grey
Yes
Application
Interior, exterior, wet areas and pools
Thickness
2 mm - 50 mm (3/32“ - 2“)
Application temperature
41 °F to 77 °F (+5 °C to +25 °C) substrate
Water demand
Approx. 3.5 l/25 kg (approx. 0.93 U.S. gals./bag)
Processing time*
Approx. 50 - 60 minutes
After approx. 3 hours
After approx. 48 hours
ZP 1 - low in chrome according to TRGS 613
Approx. 6 months in the dry area, unopened packaging
*
At 68 °F (+20 °C) and 65 % relative humidity.
Higher temperature and low humidity decrease, lower temperature and high humidity increase this value respectively.
Approx. 1.6 kg/m² per mm layer thickness / 52 ft² per 1/8” thickness
Clean tools with water immediately.
| Description | Item No. | |
|---|---|---|
| 42 x 25 kg/55 lbs | 11030 |
The aforementioned information, especially the proposals for processing and utilizing our product, is based on our knowledge and experience. We recommend that you carry out your own tests in every case to ensure the suitability of our products for the intended process and processing purposes because of the different materials and the working conditions which lie beyond our area of influence. No liability can be derived from this advice or from verbal advice, unless we are responsible for (criminal) intent or gross negligence in this respect.