Okalift SuperChange Adhesive
Acrylic based adhesive
- For Okalift SuperChange installation only
- Ready to use
- Stable consistency
- For interior only
Light colored acrylic polymer based adhesive for bonding of Okalift SuperChange Fabric on absorbent and non-absorbent substrates such as cement and calcium sulphate screeds, plaster, plasterboard, aerated concrete, ceramic flooring, terrazzo, drywall construction, plasterboard, chipboard, and plywood. Be sure substrate is screwed sufficiently in dimensionally stable structures (only in dry rooms), precast concrete and in-situ concrete.
The substrate must comply with VOB, part C, DIN 18365, 18356, 18332, 18352, and examined in accordance with technical standards before installation. Uneven surfaces must be levelled before Okalift SuperChange Fabric installation with Servofix- / Servoplan self leveling compounds. Loose and water-soluble paints must be removed. Prime absorbent surfaces, such as gypsum based cement surfaces with Okatmos® DSG or Okatmos® UG 30 in the ratio 1:1 with water. Prime non-absorbent based substrates with Okatmos® DSG or Okatmos® UG 30 full strength and let it completely dry.
Install Okalift SuperChange Fabric using attached trowel; size TKB B6. Spread the adhesive and keep the ridges up to its maximum angle and imbed fabric within 25 minutes into the fresh spread adhesive. Use the flat side of the trowel and immediately flatten the fabric/adhesive notches providing the full adhesive transfer.
Follow additional installation and floor preparation guidelines located in the latest TTMAC and TCNA installation manuals.
Color
Cream white
0,0 g/L
Application
Interior, walls and floors
Open time (working)
Approx. 25 minutes
Density
Approx. 1,6 g/cm³
Ready for traffic*
After approx. 12 hours
(Depending on ambient temperature and absorbency of the substrate)
Suitable
D 1 according to TRGS 610
EMICODE®
EC 1Plus according to GEV
Store in a frost-free place; can be stored for approx. 12 months
*
At 68 °F (+20 °C) and 65 % relative humidity. Higher temperature and low humidity decrease, lower temperature and high humidity increase this value respectively.
Approx. 800 g/m² / 200 ft² per unit with trowel size TKB B6 or 3/16” x 3/16” x 3/16” v-notch.
Installation only with TKB B6 trowel size or 3/16” x 3/16” x 3/16” v-notch
Immediately with water.
| Description | Item No. | |
|---|---|---|
| 33 x 15 kg/ 33 lbs plastic bucket | 49100 | 4015705491004 |
The aforementioned information, especially the proposals for processing and utilizing our product, is based on our knowledge and experience. We recommend that you carry out your own tests in every case to ensure the suitability of our products for the intended process and processing purposes because of the different materials and the working conditions which lie beyond our area of influence. No liability can be derived from this advice or from verbal advice, unless we are responsible for (criminal) intent or gross negligence in this respect.